Input Priority for Art-Net seems to be not working at all in 1.5.2.3 onPC

  • Hi guys,


    I am using either my "old" DOT2 or "SoundSwitch" to reuse some programmings I have already programmed and not yet ported for grandma3.


    After updating to 1.5.1.3 I found out, that my moving heads are not moving correctly anymore. A deep analysis has shown, that whatever I configure, grandma3 only accepts values above 50% for PAN and Tilt. The same for some default RGB values. It's because on an reset programmer the standard postion is at center which is 50% for my fixtures.


    As a workaround I have written apreset and a Macro to set all affected DMX parameters of affected fixtures to zero, before I start my show form DOT2 or Soundswitch.



    I have tried out all combinations of Input Priorities, but without any success.



    I have also tried out all combination in the DMX-Universe merge settings. But it got even worse and I had no Art-Net input at all.





    Does anybody has an idea here?


    Best Regards

    Sascha

  • mr-button

    Changed the title of the thread from “Input Priority for Art-Net seems to be not working at all in 1.5.2.3” to “Input Priority for Art-Net seems to be not working at all in 1.5.2.3 onPC”.