I think I mentioned this on your facebook post?
- In your grandMA3 OSC settings, the 'Page' and 'Fader' columns should say 'Page' and 'Fader' and be grayed out
- Based on your picture of TouchOSC, you also need to add 'gma3' in the 'Prefix' column of your grandMA3 OSC settings
Rayn,thank you very much!
You're right the mistake was just that I wrote "/gma3" instead of "gma3". :-/
But still commands ....
Please do not know how to send the command as is "Fixture 1 at 100"?
syntax "/cmd,s,Fixture 1 At 100" does not work
The only thing that works a bit is: "/cmd/Fixture 1 at 100", but then the Argument doesn't work
How to send an Argument in TouchOsc?
Thanks a lot!!
So I finally figured it out ....
This is a TouchOSC MK1 error. Who can't send an Argument.
The new version of TouchOSC already works without a problem.