How to edit an effect after it is stored, recall back into programmer?

  • Is there a way to recall an effect you already have saved on an executor back into the programmer?

    Say I made an 2 Color Soft effect that cycles through the fixtures I want properly, and I saved it to an executor. Is there a way to copy it to another executor, and then recall the edit window for that effect so i can change its "high value" and Low Value" to keep the phase and width attributed but change the colors?

  • Hey,

    you can do this by using the "Edit" command. So maybe you stored a 2 Color Soft effect on Cue 1, Executor 3.
    Press "Edit Cue 1 Exec 3" and open the Color Effect window. Here you can change the Low and High Value.

    Hope that helps.