Temp+go (bump effect)

  • hi,


    is it possible to create a temp+go (bump effect)?; So when i put and hold the key, the cue is going to the next cue and will be active untill i release the key.


    Thank you!

  • Hi,


    Not sure is this the result you want to achieved, but you can try put a time trigger for the next cue, so after the first cue had go it will go to the next.


    Hope this will help.

  • Interesting solution hoss! Did not know that CueZero was always trigged.

    What I saw though was that the current cue manages to control output a split second before the CueZero Go+ kicks in.


    I assume "Restart next cue" is somewhere on the list.

  • I tried the above exec configuration with Go+ Sequence # as the CueZero command, but the previous cue would flash for a split second before advancing. It was very close, but not quite right.


    Instead, try Load Next Sequence # as the OffCue cmd. I found it resulted in a much cleaner bump hit.


    Your mileage may vary.