I am having problem with the dot2 on pc. Sometimes I have only control of 4 Chanels of 36. It happens more and more feeqvent. This happens with xlr and network kable.
The XL-F joined the same network split as the PC. The signal was then sent via XLR using the node 1 K. Also tested to connect the XLR cable directly into the XL-F table. With the XL-F table, all the lights worked.
On another occasion, a other PC was tested to ensure that it was not the PC or software that was the source of error. The other lightboard then showed exactly the same problem, only 4 connected dimming channels worked to control. I have also tried with another nod 1 k, same pc and other pc, same problem.
In case of error, I have tested in the following order: restart of node, the actual data program, the entire PC. Also tested to switch between XLR and network cable as connection. no difference.
The problem seems to arise more often if the light table in a other hall is started before it is in the problem hall, perhaps just a coincidence. This show file contains nothing to block the control such as parked luminaires or DMX testers. The halls have separate universes.
It started to occur in december 2017 after uppdating to softare 220.127.116.11
Is there any known buggs or could I get my hands on a erlier version to rule that possibility out?