Have just bought a new ArtNet/sACN(E1.31) node it's a Smart Show NetDMX. This is the link to the exact node http://smartshow.lighting/netdmx/
I was under the impression that this node should work with GrandMA Dot 2 as it's on a PDF I found about how to activate your free universe of DMX output (It states at the bottom a list of suggested nodes and "SmartShow" is on there).
This PDF can be found here: http://www.ambersphere.co.uk/p…HB1dCBkb3QyIC0gMSAzLnBkZg
I have confirmed the Node is working correctly using "Q Light Controller Plus" to check I have DMX output and sure enough all works fine and DMX data is coming out of the node.
However, I can't seem to get it to work with GrandMA Dot 2. I am running it using a crossover Ethernet cable running directly into my PC, I have set the IP on the Smart show to 192.168.1.201 and a subnet mask of 255.255.255.0 and I have it in sACN mode (I Have attached a screenshot of the configuration page). I have also set a static IP on my PC as well at 192.168.1.2 and a subnet mask of 255.255.255.0 (I Have also attached a screenshot). I will also attach images of my GrandMA Dot 2 configuration page. I am probably missing something simple but any help would be much appreciated.
Thanks in advance