Posts by Luke

BECOME PART OF THE COMMUNITY - Sign up here

    Hi Steven,


    That's a nice idea.

    Like Andreas mentioned, it's not easy to do at the moment.

    If you think you need it to speed up your programming, you can try the following:


    Create an empty Sequence far away from your current Sequences (for example Sequence 1001) with two cues.

    In the CMD section of the first cue, type:

    Next Step; Off Sequence 1001

    In the CMD section of the second cue, type:

    Previous Step; Off Sequence 1001


    Then in the commandline, type:

    Assign Sequence 1001 At SpecialExec 6

    This will assign the Sequence at the right Rotary Knob.


    Then type these to assign GoFastForward & GoFastBack:

    Edit SpecialExec 6 Property "EncoderRight"

    In the pop-up, choose >>>

    Edit SpecialExec 6 Property "EncoderLeft"

    In the pop-up, choose <<<


    You can then use the same Rotary Knob to create/browse through the Steps.


    Hope that's helpful.

    The latest (3 Dec, 2019) article, I could find was by macrumours:

    Quote

    In 2016 and 2017 13-inch MacBook Pro models, the left side Thunderbolt 3 ports had reduced bandwidth due to the fact that the chips used in the machines only supported up to 12 PCI Express lanes.

    Please use F8.


    You can also click on the four corners of the screen in this order:

    Top-Left

    Bottom-Right

    Top-Right

    Bottom-Left

    For MacBook Pro Users who would like to use the grandMA3 onPC Command Wing, please use the original adapters from Apple.

    This one from example.


    Most importantly, please use the first USB-C port on right-hand side (marked in the picture attached).

    For 2016 & 2017 models (at least), the USB-C ports on the left-hand side have reduced bandwidth.

    The one on the right (marked) seem to have the highest bandwidth.


    -Luke