Posts by Anders Undelius

Okey great. I´ll see what I can find there.

Hi. I have recentley started using MA3 XT wing. I can´t get the touch to work on my 2 screens, i wonder why?

The two ViewSonic TD2760 are connected thrue DisplayPort and I have installed the driver for the screens, but so far the touch function is not working. any tips?

Kind Regards // Anders Undelius

So we seperated the whole model into several smaller ones. Now it's perfect. Thanks again

Okey great thanks Nasula I'll try that.

Hi

I have recently started working with .2 3D, lots of fun

Several 3DS files have worked just fine to import but for some reason I get the following message with one file.

"There was no import plugin which handles the content of the following files"

Before this happened I only got parts of the model imported not all 3DS-Mesh "layers".

Any ideas?

Hello

I have also tried to fix a fixture. The Martin Rush MH 6 Wash. Problem 1: I can´t get the fixture to move/target in MA 3D like it actully does in reality. PAN is inverted, therefore I should change PhysFrom/PhysTo, which only effect the 3D rendering?

Problem 2: I have big problems with importing the changed fixture (in MA fixture Builder) back to the console. The Dot 2 can only rarly find my exported file on the usb disk.

Thanks a lot in advance.

Okey kind of what i assumed, thanks for the tip. I`m not sure that it`s only when mixing cues, some cues does this anyway. I`ll try to find a specifik situation when it happens.

Kind regards Anders.

Hi

I'm having issues with fixtures snapping to zero percent. For example I'm using a executor and then want to increse intensity with the intensitywheel, The fixtures often snapps to 0%. Also it happens When pressning please two times (to lock parameters with the programmer).

Side question. should the later happen in a manual crossfade? When stoppning the fader in between 2 cues, fixtures jump to end values instead of locking where they actully are When pressning please two times.

Hi, thanks for the replys

The problem did occure on a new file as well.
there are only three different fixtures, dimmer and ETC ColourSource PAR, and Houselight 00 (also dimmer)
Yes allways the same fixtures do not respond
I did download the file from the website, just to rule out a corrupted file.
I don´t think I have tried with admin rights actully.
You will have my show file shortly

Kind regards// Anders

Hi
I am having problem with the dot2 on pc. Sometimes I have only control of 4 Chanels of 36. It happens more and more feeqvent. This happens with xlr and network kable.

The XL-F joined the same network split as the PC. The signal was then sent via XLR using the node 1 K. Also tested to connect the XLR cable directly into the XL-F table. With the XL-F table, all the lights worked.

On another occasion, a other PC was tested to ensure that it was not the PC or software that was the source of error. The other lightboard then showed exactly the same problem, only 4 connected dimming channels worked to control. I have also tried with another nod 1 k, same pc and other pc, same problem.

In case of error, I have tested in the following order: restart of node, the actual data program, the entire PC. Also tested to switch between XLR and network cable as connection. no difference.

The problem seems to arise more often if the light table in a other hall is started before it is in the problem hall, perhaps just a coincidence. This show file contains nothing to block the control such as parked luminaires or DMX testers. The halls have separate universes.

It started to occur in december 2017 after uppdating to softare 1.3.2.2
Is there any known buggs or could I get my hands on a erlier version to rule that possibility out?

You could use a pen with a eraser for better accuracy.