Output Filter doesn't filter Attributes from Sequences only Featuregroups

  • Hello Everyone,

    I have a movement phaser in a sequence, and I wanted to apply an output filter, which would only allow the Pan or Tilt attributes to pass.

    I have created two filters one with only Pan and one with only Tilt active. If I assign either to the sequence, all pan and tilt data is still being output, almost like I have done nothing. Only when I assign a filter with both Pan and Tilt unchecked, will it limit the phaser, but then it stops completely, as expected.

    Is this expected behaviour?

    Are filters only supposed to filter data from a sequence to the featuregroup level, not down to the individual attribute?

    If I use these same filters for creating presets, they work perfectly, allowing only Pan or Tilt values to pass.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!