Select a cue without activating it

Hi,

I have run into a problem that I can not figure out.

I have a cue list which only contains information about gobos, and I also have other cues such as position and color.

I want to select a cue from the cue list without triggering it. If I am running a position cue and I want to run a gobo too, I want to be able to select a gobo from my gobo cue list and activate it when I have the fader up on that executer.

In short, I want to be able to pre-select a cue within the cuelist but only GO when I bring up the fader.

Thanks for your response, but it does not seem to work. When I type the command, I get an error which is "Error #12: EXPECTED NAME:" and in the command line I see the command is "LoadShow...". I found this yesterday before I posted this thread, but I think this only works for grandMA2. Maybe I am doing something wrong.

Unfortunately not I get the same, insted of load I get LoadShow and the same error.

I found on help pages dot2, a command that is "Goto Cue x Executor x", but it activates the cue after I press please.

Can I ask what version do you run?

I use 1.9.0.1 and I use onPC as well, do you think this could be why does not work for me?

I wanted to ask if you are sure you are using Dot2, because I just took a look at the versions.

And it would not be a solution for me even if it worked, because I want to just go to the next cue without activinting it.

No problem thanks for your time!

Well, I have not found a solution for this. So for now, I would say it is not possible.