I'm testing the new funcionalities on 1.8 and I am not sure if I am missing something about recently added multipatch fixtures.
As an example I built a multipatch fixture 1001 with 4 dmx addresses added to it.
I was trying to park a certain value using the basic synthax "Park Fixture 1001 at 50", expecting to Park all dmx addresses included on this multipatch fixture.
The reslut is that only the main dmx address (Fixture 1001) is parked. The children/multipatched fixtures are not parked.
The only solution I found out until know is to Park the main fixture, then "Park Fixture 1001 multipatch 1 thru 4".
Am I doing something wrong?
There must be a much quicker/easier way to do this...
Parking multipatch fixtures is something I use quite a lot and was truly missing on previous ma3 versions.
Thanks in advance.