Phase information doesn't seem to update in phaser presets

BECOME PART OF THE COMMUNITY - Sign up here

    v1.7


    I'm having hard times on updating (at least) the phase parameter into the presets.


    Also seems that if I'm running a relative position phaser and then choose an absolute position for those fixture, the result (I think) is that the absolute value is added to relative (and not like that relative is substracted from absolute which I think might be the 'correct' way?). If, however, I first choose an absolute position and then choose a relative position phaser and then choose a new absolute position, all works fine.


    I've also complained about this before, but it seems that temp faders don't care about auto stop (off) settings in sequences settings. Which makes them pretty awful to use as size masters. Could it be I'm trying to use them in a wrong way?


    And sadly I think there's lots and lots of minor little bugs and oddities all over the place. It's quite annoying and odd really.


    cheers.

    Quote


    I've also complained about this before, but it seems that temp faders don't care about auto stop (off) settings in sequences settings. Which makes them pretty awful to use as size masters. Could it be I'm trying to use them in a wrong way?

    a temp fader never uses auto start stop, because moving a tempfader is actually fade in and out the cue data.

    Fadermasters only control dimmer values, that why you can have the auto start/stop setting

    Ok, that makes sense and means my idea of the problem is wrong. But still if using a temp fader on a sequencer with multiple cues makes the seq go to the next cue, when running temp down and up again. Nevertheless of the sequencer settings.

    Quote from albinotoni

    Ok, that makes sense and means my idea of the problem is wrong. But still if using a temp fader on a sequencer with multiple cues makes the seq go to the next cue, when running temp down and up again. Nevertheless of the sequencer settings.

    if you dont want to go to the next cue, check the restart settings of the sequence

    Change The go+ Button below temp Fader to something Else like load. Then The restart mode will work.

    Edit. Noticed that The Fader must Be at 0% when you load The next cue. After that u can go from 0 to 100 as many times you want and it will stay on same cue.

    Edited once, last by Rikurama ().

    Hi Albinotoni,


    we discussed this issue in the following thread and i tried to show a workaround. Maybe it helps you too, if you take the basic information for your setting:


    Thread
    Temp fader acting as go
    Hi, here's another question:

    Gma3 1.5.2.1. I have a sequence with multiple cues having different (relative) p/t phasers on them. I'd like the fader control the size of the effect, so I assigned it as a temp. 'Auto start' and 'stop' are off. I go through different cues (tiltmoves, circle etc..) with GO. Everytime after GO, raising the (temp)fader acts as GO for the next cue (but only after pressing the actual GO first. Also turning off the temp fader launches the off-cue (despite 'auto stop'…
    albinotoni


    Regards


    Henrik

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login