Hello there.
Using onPC,3d(on same PC) and node.I`m having trouble with switching between node which I use in event and dot2 3d when I`m at office.
So generally, In event I`m using dot2 node(using ethernet connection), if I need something to change or whatever(event is already ended and NO node connected) Im switching on Pc to virtual internet driver(both on PC and 3d ar set to same). When I click add 3d(in setup window) it adds it, connect to it, but then it crushes(no message or anything happens) on PC just stop working, I cant do anything, only close 3d, then on Pc working again. Usually I need to do this like 3 times till everything is ok(doing same thing all over again).
I`m very sorry about bad english, but I hope someone will get it.
Long story short, I need atleast 3 times to start both programmas, doing same thing. With node there is no problem.
Edited: The heart in 3d, goes from red to green, and then back to red(like disconecting)