Sorry for bringing up an old subject again, but these threads did not solve my issue.
I am not succeeding making a working Pan Tilt Controller.
This is what I have done:
1. A ABS Preset (or in the programmer) on Master 1.
2 A REL Circel Phaser on Master 2. LTP priority (the phaser could also been activated in the programmer).
As far as this goes. Everything works as expected. Even if I change programmer value on ABS P/T Position. the REL Circle effect works in relation to the ABS P/T Values in the programmer.
3. Now. I want to kick in the controller.
A REL STOMP (or zero) value recorded on TEMP master 3. Assigned to SUPER or HIGHEST Priority.
Ok. This does not work.
Expected result: The on going phaser should DECREASE in relation to the ABS value from the programmer.
Ex: ABS programmer Value: -50. "Controller" should end on that -50 value.
Result I get: My Master 3 act like a ABS value. It DECREASE the phaser perfectly , but it end on that ABS value (zero).
It doesn't work in relation to the actual value in the programmer.
Is there something in MA3 concept that I do not understand?
Thanks in advance