1.5.2.3 Temp fader and hazer

BECOME PART OF THE COMMUNITY - Sign up here
  • Since updating I can’t get a temp fader working on my hazer. I stor a sequence with the hazer running at full on a fader and change the fader from master to temp, but when I raise the fader the hazer jumps directly to 100 instead of following the fader.
    When I do the same in 1.4.2.1 it works perfectly, but when I open the same show in 1.5.2.3 it jumps to 100 again.
    Anyone else experiencing this?

  • On closer inspection it’s actually working as it should. It’s only in the fixture sheet it says that it’s running on full, but the actual hazer is operating at the value of the fader.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!