IfProg and IfActive only work with Dimmer Values

So I hadn't noticed this in before but it seems that IfProg and IfActive both only work with Dimmer values (as if it was IfOutput but including 0).

• Patch Moving lights (anything with more than Dimmer Attributes)
• Fixture 1
• On EncoderPage 2 Thru 7 turn on everything except dimmer attributes
• Fixture 2
• IfProg or ifActive

I would expect Fixture 1 and 2 are selected but only fixture 2 is selected not adding the ifProg or IfActive Commands. If you turn on EncoderPage 1 it works as expected.

Same thing happened in 1.4, not sure about earlier.

Ahh ok, a case of not knowing what I don't know. I thought I understood how both worked so I didn't bother looking at the manual.

Thanks for the workaround though.

Is the intention for IfProg and Active to work as they did in MA2 or is this the the new way?