I'm wanting to run just one cycle of a phaser and have it stop once it finishes its last step. How might i go about doing that?
BECOME PART OF THE COMMUNITY - Sign up here
In your command section you have a button that say single step, or maybe you can achieve that just making a dynamic preset with phase and delay time?
In your command section you have a button that say single step
The single step is meant for the programmer, it allows stop on the selected step.
Unfortunately Single Step, Repeat and Bounce are not implemented yet.
As Chieffcrew says you can create a multi-step preset with delay times for each parameter or you could also create a multi part cue in the same way. Now you can also can even use atMAgic presets if the effect is linear.