hi,
is it possible to create a temp+go (bump effect)?; So when i put and hold the key, the cue is going to the next cue and will be active untill i release the key.
Thank you!
Temp+go (bump effect)
BECOME PART OF THE COMMUNITY - Sign up here
-
-
Hi,
Not sure is this the result you want to achieved, but you can try put a time trigger for the next cue, so after the first cue had go it will go to the next.
Hope this will help.
-
Thank you for your reply!
Yeah, I made that. But I want to be able to hold the effect with the key
-
This might work, on the executor:
- Set the key to Temp
- Turn off Restart First Cue
- in CueZero add the cmd Go+ Sequence #
-
Interesting solution hoss! Did not know that CueZero was always trigged.
What I saw though was that the current cue manages to control output a split second before the CueZero Go+ kicks in.
I assume "Restart next cue" is somewhere on the list.
-
Yeah it's not ideal, specifically for slow paramiters. I initially tried it on the OffCue, but that caused the executor to stay on and Go+ Seq#; Off Seq # was a very bad idea!
-
I tried the above exec configuration with Go+ Sequence # as the CueZero command, but the previous cue would flash for a split second before advancing. It was very close, but not quite right.
Instead, try Load Next Sequence # as the OffCue cmd. I found it resulted in a much cleaner bump hit.
Your mileage may vary.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!