Ok so after 10 days of experimentations I will pack to console and the WYSIWYG and load in to the theatre tomorrow. I can say I am pretty confident about programing this new show with the MA3 soft.
I have had some issues with the users and I made the console crash many times but it seems to be running smooth now. I have changed my user profile and since then I had zero problems. The only thing different is with the Value readout. It was in Physical on my previous profile and now its in Percent. This should'nt be an issue but it seemed to be because I wasn't getting proper reading out of the WYG (MA 3D was ok though??) I could not delete groups and the console crashed when deleting specific sequences. The Value readout is the only thing I changed in the user. As i said, for the last few days it's been pretty solid, no crash no big things.
I found out that when I am recording new focus presets starting from an existing preset, some of the fixtures dont respond. I need to clear and to start from the original value of the fixture and then it works. (so far it happened only with the focus preset..)
When recording gobo preset I normaly like to record them with the rotation@ stop in the middle so They are always ready to turn slow. I have not been able to do it on this one it doesn't seem to record those values.
Can someone tell me what happened to the MA AT function? is it just not operational?
I have some BMFL with shutters and I cant find the super Shaper window like in the MA2...
When using the phase editor window to move fixtures it would be nice if they could just move and not start to go between two points as default. having to look in the window and change the function is a step I could do without.
OK that's it for now. JF