Hi, Simple question. I have a pan tilt circle in cue 1 and I want to go to a fix position in cue 2 and I want the phaser to follow the timing of my sequence and move slowly to the next position (just like the dimmers) How do you do it? it goes like a snap I cant seem to find the right time button... Thanks
Hi there seems to be a bug at the moment....normally you just select a position preset and store it with a fade time.
Hi Daniel, is it possible something is wrong with users? I have a full size3 connected to a wysiwyg. I have created a new user to be my user for GMA3 (I have just created it, assigned it to a new profile with admin rights and gave it an appearence I did no other modifications)
As I have mentioned in some previous post when deleting certain sequences from the sequence pool the console would reboot. Always the same sequences would make this happen. I then switch back to Admin user and try to delete and everything works perfect...
I have some show batten patched in pixel mode. In my user, I enable the pixel mode in the control section and when I look at my fixture sheet i see a single 1.0 as value in control. Of course the fixture doesn't work in the wyg but strange enough it does in the 3D...
I switch user back to admin and Voila! I have Values and I can control the fixture as usual and it works great. It works in the 3D as well as in WYG..
It was the value Readout that read physical instead of percent.