Hello everyone,
I got a problem.
I want to make a one-flash,
that means If I press a flash button the lights should turn on instantly and after a short amount of time it should fade out no matter for how long I hold the flash button.
Can someone help me?
Thanks
Store your fixtures and values to cue 1.
Clear programmer and store a second empty cue to this executor (nothing selected, just press Store and add second cue)
Write the following command to the CMD Column in cue 2: Off Executor x.y
If you use Executor 101 on page 1 than it would be Executor 1.101
Change the Cue Trigger (Trig) to Time and set a Trig Time of x seconds for cue 2.
If you now start cue 1 cue 2 gets executed in the time you set as Trig Time and the Executor gets switched off.
Thanks for the fast reply. Works good so far, but the fade out does not really exist. How to set up the fade out?
use Off Time in Executor settings view.
Thank you very much, works perfectly fine. I got another question: Is it possible to link the sound input and BPM faders from the tools menu to my executor?
Yes it's also possible. Open the cues view for the Executor and select Sound or BPM as cue Trigger.
http://help2.malighting.com/Pa…iewitem_selecttrig/en/1.3
Thanks for the fast answer, you discribed how to set up the cue trigger, but what I really meant is If its possible to link the faders called sound input and BPM from the tools menu to the executor. I dont want to open the tools menu every time I want to adjust for example the BPM. Is there any possibility to get this done?
Sorry. I don't see a way to assign the BPM or Sound In to a fader. I'm not at the console right now but will check later.
Don’t have an account yet? Register yourself now and be a part of our community!
